Description
General Suction and Discharge Hose technical overview
General suction and discharge hose for water, slurry, light oil and utility transfer where a helix-supported hose is required.
Catalog-based construction and application
| Tube | Synthetic rubber liner selected for transfer media. |
|---|---|
| Reinforcement | Textile reinforcement with helix wire. |
| Cover | Weather and abrasion resistant industrial cover. |
| Working pressure | Catalog reference: 20 bar for smaller sizes and 10 bar for larger sizes. |
| Temperature | -30 C to +80 C typical transfer service. |
| Standard / reference | Indo Hydraulics suction and delivery hose catalog family. |
| Application | Water suction, drainage, irrigation, light slurry and plant maintenance transfer. |
| Fitting compatibility | Camlock, flange, threaded adapters or clamp-end assemblies. |
Size and pressure reference
The table below follows the dimensional pattern shown in the Indo Hydraulics hose catalog. Final hose assembly selection should confirm fluid, impulse load, route radius and crimp fitting series.
| I.D. inch | I.D. mm | O.D. mm | W.P. MPa / psi | Bend radius mm | Weight kg/m |
|---|---|---|---|---|---|
| 1/2" | 13 | 22 | 20 / 300 | 65 | 0.31 |
| 5/8" | 16 | 25 | 20 / 300 | 80 | 0.37 |
| 3/4" | 19 | 29 | 20 / 300 | 95 | 0.50 |
| 1" | 25 | 36 | 20 / 300 | 125 | 0.67 |
| 1-1/4" | 32 | 44 | 20 / 300 | 300 | 0.95 |
| 1-1/2" | 38 | 51 | 20 / 300 | 360 | 1.18 |
| 2" | 51 | 66 | 20 / 300 | 450 | 1.75 |
| 3" | 76 | 92 | 10 / 150 | 750 | 2.65 |
| 4" | 102 | 118 | 10 / 150 | 1000 | 3.81 |
Selection notes for buyers
- Use suction/discharge hose selection by media, vacuum demand, cover abrasion and routing conditions.
- Confirm liner compatibility for oil, chemical, cement, water, air or hot media before order.
- For bulk users, keep common lengths and end connections ready for maintenance shutdowns.
FAQ
Can this hose be supplied as a crimped hose assembly?
Yes. Indo Hydraulics can match hose, ferrule and fitting type for replacement or project supply, including BSP, JIC, ORFS, NPT and DIN metric connection patterns.
Which size should be stocked for maintenance?
Fast-moving maintenance sizes usually depend on the equipment population. For mobile hydraulic lines, 1/4 inch to 1 inch sizes are common; for industrial transfer hose, 1/2 inch to 4 inch sizes are often requested.
How should pressure be confirmed?
Choose by working pressure, burst margin, bend radius, temperature and fluid compatibility. Do not select by hose size alone.
Reviews
There are no reviews yet.